Big Beach Bar - 1.250 diameter
BIG BEACH BAR - DIMPLED AND DRILLED FOR INTERNAL WIRING
This bar can be used with the throttle by wire system or with conventional throttle cables. It can also be used with hydraulic or cable clutch.
Height: 2.875"
Width: 38.5”
Pull Back: 15.75”
Center Width: 9.5"
Tube Dia: 1.25”
*Bars taper down to 1" diameter in the hand control areas so you can run aftermarket controls, and / or a hydraulic clutch. May require longer cables and brake lines.
*NOTE: In our experience, when installing these bars on HD touring models, you will only have to use longer cables and brake lines. The wiring has always been long enough. When using these bars on batwing fairing models, you will have to trim the plastic around the handlebar opening on the rocker switch cover only.
Email to a Friend
Be the first to review this product
$174.99
